Fingerboard Locating Jig

The ELEVATE Fingerboard Locating Jig is designed to take the guess work out of aligning a fretboard on a neck for glue ups.  The jig easily and accurately locates in two different ways- via the truss rod slot or by clamping onto straight or tapered outside edges.  This is achieved by utilizing either the included truss rod centering pins or by using the built-in articulating clamps.

This jig’s body contains four hardened drill bushings that ensure accurate and repeatable drill locations in both the neck and the underside of the fingerboard.  Once the holes are drilled in each part, simply insert a 3/16″ plastic locating pin in each hole and snap the parts together.

Add a depth stop for added accuracy and don’t forget to use a sharp drill bit.

Use carbon fiber reinforcement rods in your necks?  Check out the Truss Rod Slotting Jig Plus for a wider bushing spacing.

See more information below under the “product information” tab.