M&T Routing Jig


The ELEVATE M&T Routing Jig makes it simple to route the body connection joint regardless of the neck set angle. The aluminum construction makes this an extremely rigid setup without flex.  Easily center the jig on the neck or body with the truss rod centering pin or the centerline indication edge.  The top routing plate of the jig pivots to conform to the angle of the body and neck and is locked in place with 2 screws on the side of the jig.  Clamp everything in place, and route.  It’s that simple.

The resulting mortise and tenon joint is compatible with the ELEVATE Variable M&T Drilling Jig.

Need a wide range of joint length?  Check out the ELEVATE Variable M&T Routing Jig.

Be sure to use a fresh, sharp, high quality template bit for best results.

Pairs well with the ELEVATE Neck Angle Jig.

See more information below under the “product information” tab.

SKU: MTR Category:

Additional information

What's Included

-M&T Routing Jig Body (choice of size)
-Angle Plate
-(1) Universal Truss Rod Centering Pin


-All aluminum construction
-Conforms to the angle of the body and neck for precise routing
-Mortise is slightly longer than tenon to ensure no length interference issues regardless of neck set angle
-Easily center-able via truss rod slot
-Resulting mortise and tenon are compatible with the ELEVATE Variable M&T Drilling Jig
-Works with all common neck angles
-Joint length: Tenon- 3", Mortise- 3.2" (depends on neck angle)